120A EV Power Connector datasheet and drawing request
Request controlled technical files for 120A EV Power Connector, including datasheet, 2D drawing, 3D STEP file, terminal information and sample review support.
Product reference
Model: AC-HV-120
Category: high voltage connectors
Pin: 2 Pole
Voltage: 600V
Current: 120A
IP: IP67
Available file paths
Request the right engineering file package
Some files can be prepared from standard product data. Controlled drawings and STEP files require product model and application confirmation.
Datasheet PDF
Specification, material, electrical rating, application and model reference.
2D Drawing
Dimensions, cavity layout, latch direction, terminal and mating interface reference.
3D STEP File
Engineering fit review for module packaging, harness routing or assembly space.
Sample Review
Sample, drawing, photo or reference model review before quotation.
Current file status
Datasheet: Pending
2D Drawing: On Request
3D STEP: On Request
Product Image: Pending
Engineering review required before quotation.
File request checklist
Product model: AC-HV-120
Application: EV Power Distribution
Vehicle system: EV Power Distribution
Required file type: datasheet, drawing, STEP, terminal drawing or sample
Drawing, sample photo or reference connector if available
Release control
Why drawings and STEP files are RFQ gated
Automotive connector technical files should match the actual model, terminal, seal, mating side and project application.
Datasheets can be public or RFQ-gated depending on product maturity.
2D drawings and 3D STEP files should be controlled for engineering review, not exposed blindly.
High-voltage, EV and OEM/ODM files should require application context before release.
Every downloadable file should connect to product model, revision, date and owner.
If a product image is still pending, the file center should clearly mark it before launch.
Request files for 120A EV Power Connector
Send file type, application, drawing requirement and project status. WEUP will review whether datasheet, 2D drawing, STEP file or sample support is the right next step.